Honeywell XI581AH User Manual page 66

ALPHABETIC REFERENCE
EN2B-0126 (74-3554-8)
Edit DIO Module Assignment
Address: 04
! XFL523
XFL523
* XFL523
Special characters indicate the module status according to the following key:
! An exclamation mark indicates that the module was previously assigned to this
controller in CARE but is now being used by another controller.
* An asterisk indicates that the module is being used by another controller. It is
displayed because module type and address match.
A blank indicates that this module is free and can be used for assignment.
7. Select a module by using the arrow keys to move to and highlight it and then
pressing Enter (↵).
RESULT: The assignment is accepted and the first 'Distributed I/O Module
Assignment' screen is displayed again.
DIO Module Assignment
02 ? XLF521
03
04 - XFL522
05 XFL524
Another method to select a module is to press its L
result of step 6 is displayed.
RESULT: If the L W
ON ORKS
displayed:
Edit DIO Module Assignment
Module : 04 XFL523
Neuron ID: 0001FC234088
ASSIGN
8. Assign is highlighted by default. Press Enter (↵) to accept the assignment or
press Cancel (C) to return to the previous screen.
RESULT: If the assignment is accepted, the first 'Distributed I/O Module
Assignment' screen is displayed again.
Edit DIO Module Assignment
02 ! XFLF521
04 ? XFL523
05 XFL522
08 XFL524/29
IMPORTANT
After making any changes to the Distributed I/O module assignments, the
application must be saved to Flash memory so that the application will start
with the same module assignment after any kind of restart.
62
XI581/2 BUSWIDE OPERATOR INTERFACE
L L L L
Unassign
0001FC234088 1
I
0001FC334056
M
0001FC234062
L L L L
0001FC234088
<Unassigned> 1
I I I I
0001FC234088
M
0001FC234062
W
ON
service pin is pushed, the following screen is
L L L L
0001FC234056
0001FC234088 1
I
<Unassigned>
M
IP-Bus Board
service pin while the
ORKS