Honeywell XI581AH User Manual page 65

XI581/2 BUSWIDE OPERATOR INTERFACE
ATTENTION
While next mask is displayed, the
DIO value processing is disabled!
BACK
5. Use the arrow keys to move to and highlight CONTINUE and press Enter (↵) to
complete the selection.
RESULT: The display window lists the all Distributed I/O modules needed for the
loaded applications, even if they are unassigned.
Edit DIO Module Assignment
02 ! XFLF521
04 ! XFL523
05 XFL522
08 XFL524/29
Modules that have been assigned have their module type and Neuron ID displayed
beside them. Special characters indicate the status module according to the
following key:
! An exclamation mark indicates that the module was previously assigned to this
controller in CARE but is now being used by another controller.
- A minus sign indicates that the module is assigned but not yet commissioned.
This is the default state after assignment.
? A question mark indicates that the module is assigned but not available or not
found during commissioning.
If no special character is seen alongside a module name, this indicates that the
module is correctly assigned and commissioned.
NOTE: This screen is refreshed to show changes of state of the modules, such as
if the module is assigned to another controller, the conflict will be
displayed.
6. To change an assignment, select any line (module address) by using the arrow
keys to move to and highlight it and then pressing Enter (↵). If a specific module
is selected, an intermediate mask is displayed, while the controller searches on
the L W network for all modules with the specified module address and
ON ORKS
module type.
Please be patient, while
DIO Modules will be searched
After a brief period, the next screen is displayed. The display window
lists all modules of the same type and of the same address. The
search can be canceled by pressing Cancel (C).
61
ALPHABETIC REFERENCE
CONTINUE
L L L L
0001FC234056
0001FC234088 1
I
<Unassigned>
M
IP-Bus Board
EN2B-0126 (74-3554-8)