Clearances; Assembly; Gas Connection - Buffalo CD963 Instruction Manual

Installation

Clearances

NOTE: Only non-combustible materials can be used in close proximity to this appliance.
Left / Right Hand Side
Rear

Assembly

NOTE:
•
This appliance is assembled before delivery except feet & regulator.
•
This appliance is fitted with adjustable feet to enable the appliance to be positioned securely and level. This
should be carried out on completion of the gas connection. Refer to the „Gas Connection‟ section.

Gas Connection

NOTE: ALL GAS FITTING MUST ONLY BE CARRIED OUT BY A QUALIFIED PERSON.
1. These Gas Griddles do not require an electrical connection, as they function totally on the gas
supply only.
2. It is essential that the gas supply is correct for the appliance to be installed and that adequate
supply pressure and volume are available. The following checks should therefore be made
before installation:-
a. Gas Type the appliance has been supplied for is shown in the rating label. Check that this is
correct for the gas supply the appliance is being installed for. The gas conversion procedure is
detailed in this manual.
b. Supply Pressure required for this appliance is shown in the „Specifications‟ section of this manual.
Check the gas supply to ensure adequate supply pressure exists.
c. Input Rate of this appliance is stated on the Rating label .The input rate should be checked against
the available gas supply line capacity. Particular note should be taken if the appliance is being added
to an existing installation.
NOTE: It is important that adequately sized piping runs directly to the connection joint on the appliance
with as few tees and elbows as possible to give maximum supply volume.
3. Fit the gas regulator supplied, into the gas supply line as close to the appliance as possible.
NOTE: The gas pressure regulator provided with this appliance is convertible between Natural Gas and
propane as per the „Gas Conversion Section‟ in this manual.
Ensure the regulator is converted to the correct gas type that the appliance will operate on. The
regulator outlet pressure is fixed ex-factory for the gas type that the regulator is converted to and
it is NOT to be adjusted.
Combustible Surface
250mm
250mm
6
Non Combustible Surface
0mm
0mm