Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Buffalo CD963
Summary of Contents for Buffalo CD963
- Page 1 Gas Griddle Instruction Manual Model: CD963 CD964...
-
Page 2: Table Of Contents
Contents Gas Griddle CD963 Gas Griddle CD964 Gas Griddle Introduction ..................... 2 Specifications ................... 3 Model Numbers Covered in this Specification General Gas Supply Requirements Gas Connection Dimensions ....................4 Installation ....................5 Installation Requirements Unpacking Location Clearances Assembly Gas Connection Commissioning Operation .................... -
Page 3: Introduction
Introduction We are confident that you will be delighted with your GAS GRIDDLE, and it will become a most valued appliance in your commercial kitchen. To ensure you receive the utmost benefit from your new GAS GRIDDLE, there are two important things you can do. -
Page 4: Specifications
A commercial heavy duty, fully modular, gas fired griddle using a thermostatic burner system and fitted with stainless steel burners with full pilot and flame failure protection and piezo ignition. It uses a 19mm thick griddle smooth plate Pack Contents The following is included: BUFFALO Gas Griddle Regulator Feet ... -
Page 5: Dimensions
Dimensions Dimensions for Bench Models CD963: 804. 5 610. 0 69. 5 441. 0 544. 0 CD964: 804. 5 915. 0 69. 5 441. 0 849. 0... -
Page 6: Installation
Check that the available gas supply is correct to that shown on the rating plate located on the right hand panel. Location Installation must allow for a sufficient flow of fresh air for the combustion air supply. Combustion Air Requirements: CD963 CD964 GP518 Natural Gas (G20) 14.5 m... -
Page 7: Clearances
Installation Clearances NOTE: Only non-combustible materials can be used in close proximity to this appliance. Combustible Surface Non Combustible Surface Left / Right Hand Side 250mm Rear 250mm Assembly NOTE: • This appliance is assembled before delivery except feet & regulator. •... -
Page 8: Location
Installation The regulator connections are " BSP female. The connection to the appliance is " BSP male. (Refer to the „Specifications‟ section for the gas supply location dimensions). NOTE: A Manual Isolation Valve must be fitted to the individual appliance supply line. Correctly locate the appliance into its final operating position and using a spirit level, adjust the legs so that the unit is level and at the correct height. -
Page 9: Operation
Operation Operation Guide CAUTION: • THIS APPLIANCE IS FOR PROFESSIONAL USE AND IS ONLY TO BE USED BY QUALIFIED PEOPLE. • ONLY QUALIFIED SERVICE PERSONS ARE TO CARRY OUT INSTALLATION, SERVICING OR GAS CONVERSION OPERATIONS. • COMPONENTS HAVING ADJUSTMENTS PROTECTED (E.G. PAINT SEALED) BY THE MANUFACTURER SHOULD NOT BE ADJUSTED BY THE USER/OPERATOR. -
Page 10: Lighting The Pilot Burner
Operation WARNING: SURFACE TEMPERATURE OF THE GRIDDLE PLATE CAN REACH OVER 300°C WHEN THE APPLIANCE IS OPERATED AT FULL SETTING. Lighting the Pilot Burner These griddles are fitted with a pilot as a standard option and flame failure protection, which is incorporated for each main burner, by way of a thermo-electric system. -
Page 11: Cleaning And Maintenance
Cleaning and Maintenance CAUTION: Always turn off the gas supply before cleaning. This appliance is not water proof. Do not use water jet spray to clean this appliance. General Clean the griddle regularly. A clean appliance looks better, will last longer and will perform better. Carbonised grease on the surface or on the griddle plate will hinder the transfer of heat from the cooking surface to the food. -
Page 12: Daily Cleaning
Cleaning and Maintenance Daily Cleaning The grease drawer should be checked and emptied frequently to prevent overflow and spillage. Remove the grease drawer while still warm so that the grease is in a liquid state. Empty any grease from the drawer and wash thoroughly in the same manner as any cooking utensil. Clean the Control Panel with a damp cloth lightly moistened with a solution of mild detergent and water. -
Page 13: Trouble Shooting
Trouble shooting This section provides an easy reference guide to the more common problems that may occur during the operation of your equipment. The fault finding guide in this section is intended to help you correct, or at least accurately diagnose problems with your equipment. Although this section covers the most common problems reported, you may encounter a problem not covered in this section. -
Page 14: Gas Conversion And Specifications
Gas Conversion and Specifications Conversion Procedure CAUTION: Ensure that the appliance is isolated from the gas supply before commencing servicing. NOTE: • These conversions should only be carried out by qualified persons. All connections must be checked for leaks before re-commissioning the appliance. •... - Page 15 Gas Conversion and Specifications Gas Regulator NOTE: The regulator supplied is convertible between Natural Gas and propane, but it‟s outlet pressure is fixed ex-factory and is NOT to be adjusted. NOTE, Pin rotated for Natural Gas NOTE, Pin rotated for propane Ensure that the gas supply is turned „OFF‟...
-
Page 16: Gas Specifications
NOTE: If for some reason it is not possible to get the appliance to operate correctly, shut off the gas supply and contact the supplier of this appliance. Gas Specifications Appliance Classification Category: II2H3P & II2L3P Flue Type: Natural Gas (G20) Natural Gas(G25) Propane (G31) CD963 CD963 CD964 CD963 CD964 CD964 Main Burner Injector 2.28mm 2.50mm 2.50mm 1.51mm... -
Page 17: Replacement Parts List
Gas Conversion Kits Part name Code Categories Country CD963 CD964 Main injector 40#(G25 Only) 1470544 Pilot injector 0.45mm (NAT gas) GB IE ES IT AT CH Main injector 43#(G20 Only) -
Page 18: Explosion Drawing
Explosion drawing... -
Page 19: Spare Parts List
Base plate CD963 Base plate CD964 Body ass'y/lower CD963 Body assy /lower CD964 Regulator AC127 Back plate CD963 Back plate CD964 Griddle plate ass'y CD963 Griddle plate ass'y CD964 ODS ass'y AC128 Gas pipe of main burner AC132 Main Injector 40# AC121... - Page 20 Equipment Type • Uitrustingstype • Type d'équipement • Gerätetyp • Gas Hobs & Griddles Tipo di apparecchiatura • Tipo de equipo • Tipo de equipamento Model • Modèle • Modell • Modello • Modelo • Malli CD963-N, CD963-P, CD964-N, CD964-P Gas Appliances Directive Application of Council Directives(s) Toepassing van Europese Richtlijn(en) •...