Table of Contents
Advertisement
Installation
Installation Requirements
NOTE:
•
It is most important that this appliance is installed correctly and that operation is correct before use.
Installation shall comply with local gas, health and safety requirements.
•
This appliance shall be installed with sufficient ventilation to prevent the occurrence of unacceptable
concentrations of substances harmful to health.
Our Gas Griddles are designed to provide years of satisfactory service and correct installation is essential to
achieve the best performance, efficiency and trouble-free operation.
This appliance must be installed in accordance with National installation codes and in addition, in accordance
with relevant National / Local codes covering gas and fire safety.
United Kingdom:
Ireland:
Installations must be carried out by qualified persons only. Failure to install equipment to the relevant
codes and manufacturer‟s specifications shown in this section will void the warranty.
Components having adjustments protected by the manufacturer are only to be adjusted by an authorised
service agent. They are not to be adjusted by the installation person.
Unpacking
•
Remove all packaging and transit protection from the appliance including all protective plastic coating from the
exterior stainless steel panels.
•
Check equipment and parts for damage. Report any damage immediately to the carrier and distributor.
•
Ensure that the 4 adjustable feet are fitted with the protruding centre screw.
•
Report any deficiencies to the distributor who supplied the appliance.
•
Check that the available gas supply is correct to that shown on the rating plate located on the right hand panel.
Location
1.
Installation must allow for a sufficient flow of fresh air for the combustion air supply.
Natural Gas (G20)
Natural Gas (G25)
Propane (G31)
2.
Installation must include adequate ventilation means, to prevent dangerous build up of combustion
products.
3.
Any gas burning appliance requires adequate clearance and ventilation for optimum and trouble-free
operation. The minimum installation clearances shown below are to be adhered to.
4.
Position the appliance in its approximate working position.
5.
All air for burner combustion is supplied from underneath the unit. The legs must always be fitted
and no obstructions placed on the underside or around the base of the unit, as obstructions will
cause incorrect operation and / or failure of the appliance.
6.
Components having adjustments protected by manufacturer are only allowed to be adjusted by an
authorised service agent. They are not to be adjusted by the installation person.
NOTE: Do not obstruct or block the appliances flue. Never directly connect a ventilation
system to the appliance flue outlet.
- Gas Safety (Installation & Use) Regulations 1998.
- BS6173
- Installation of Catering Appliances.
- BS5440
- 1 & 2 Installation Flueing & Ventilation.
- IS 820
- Non - Domestic Gas Installations.
Combustion Air Requirements:
CD963
3
14.5 m
/hr
3
14.5 m
/hr
3
15.0 m
/hr
5
CD964
GP518
3
21.8 m
/hr
3
28 m
/hr
3
21.8 m
/hr
3
22.5 m
/hr
3
29 m
/hr
Advertisement
Table of Contents
