Resetting the Terminal
There are two types of system resets: a Hard Reset or a Factory Reset. The hard reset preserves all
data stored in the file system. Contact a Honeywell technical support representative for information on
how to perform a Factory Reset. For contact information, see
Hard Reset (Cold Boot)
A hard reset re-boots the device and closes any open applications running in RAM at the time of the
reset.
1. Press and hold the Power button
2. Touch Reboot.
Note: To perform a Hard Reset if the touch screen has stopped responding, press and hold the Power button
for approximately 8 seconds until the terminal starts to re-boot. When the reset is complete, the Lock screen
displays.
Connecting the Terminal to a Computer via a USB Connection
You can transfer files (e.g., pictures, music, and videos) between your computer and the terminal using
the supplied USB Charge/Communication cable or a Dolphin 70e Black HomeBase with a standard USB
cable.
Note: The terminal supports Hi-Speed USB communication (USB 2.0) with a maximum data transfer rate of
480 Mbps.
1. Connect the terminal to your computer using the USB Charge/Communication cable supplied.
USB Door
2
USB Charge/
Communication Cable
Note: A USB connection notification
been established.
2. Touch Turn on USB storage when the USB Mass Storage screen opens.
until the Phone Options menu displays.
1
Right Side Panel of Dolphin 70e Black
3
Micro
USB
Port
appears on the status bar to indicate the hardware connection has
Technical Assistance
High-Power USB Port on
Host Device
on page
14-1.
2 - 15