Bottom Panel; Power; Connecting Power To The Net Base - Honeywell Dolphin 70e Black User Manual

DC Power Jack
This connector receives input from the power adapter. Plug the power connector cable from
the power adapter into this connector, see Power.

Bottom Panel

For details on how to mount the base, see
Serial Number
Label

Power

The terminal requires 12 Volts DC input for battery charging and power output to the terminal. The power
adapter included with the base, converts the voltage from the AC power source to 12 volts DC. Use only
a UL Listed power supply, which has been qualified by Honeywell with output rated at 12VDC and
5 amps with the device. The operating temperature range is -10° to 50°C (14° to 122°F).
Honeywell recommends that you leave the Net Base connected to its power source at all times, so that it
is always ready to use.
We recommend use of Honeywell peripherals, power cables, and power adapters. Use of any non-Honeywell
peripherals, cables, or power adapters may cause damage not covered by the warranty.

Connecting Power to the Net Base

1. Plug the A/C power cord into the power
adapter.
2. Plug the power cable into the power
connector on the back of the Net Base.
3. Plug the A/C power cord into a grounded
power source.
4. The base is ready to begin charging
terminals.
13 - 4
Mounting the Net Base
Compliance Label
A/C Power
Cord
on page 13-6.
MAC Address Label
Power LED
Power Adapter
Power
Connector
Cable