Linksys WVC54GCA User Manual page 7

Chapter2
6. Plug the included power adapter into the Camera's
Power port. Plug the other end into an electrical outlet.
Click Next.
Power On the Camera
7. Make sure the LED is lit on the Camera's front panel. If it
is not lit, make sure the cables are properly connected
to the Camera. Click Next.
Check the LED
8. The Wizard searches for the Wireless-G Internet Home
Monitoring Camera on your network, then displays the
Camera found along with status information.
Camera Found on Network
Wreless-G Internet Home Montorng Camera
Setting Up and Mounting the Camera
If the Camera you want is not displayed, click Search
Agan to run a new search for Cameras.
Otherwise, in the Camera List box, click the name of the
Camera you are installing. Write down the Camera's IP
address shown in the Status box, so you can use it to
access the Web-based Utility later. Click Next.
9. Enter a name for the Camera. Memorable names are
helpful, especially if you are using multiple Cameras
on the same network. It should have 15 characters or
fewer. After you have entered the name, click Next.
Assign the Camera Name
10. Select how to assign an IP Address to the Camera,
either automatically or manually. Then click Next.
IP Address Settings
Automatcally obtan an IP Address
•
option if you want to automatically assign an IP address
to the Camera using DHCP.
If you are not sure which option to choose, Linksys
recommends this option.
Set IP address confguraton manually
•
this option if you want to manually assign a static IP
address to the Camera.
If you select this option, fill in the IP Address, Subnet
Mask, and Gateway fields.
Select this
Select