Cisco 7965G Administration Manual page 116

Telephony Features Available for the Phone
Table 5-1 Telephony Features for the Cisco Unified IP Phone (continued)
Feature Description
Hunt Group Provides load sharing for calls to a main
directory number. A hunt group contains a
series of directory numbers that can answer
the incoming calls. When the first directory
number in the hunt group is busy, the system
hunts in a predetermined sequence for the
next available directory number in the group
and directs the call to that phone.
Immediate Divert Allows a user to transfer a ringing, connected,
or held call directly to a voice-messaging
system. When a call is diverted, the line
becomes available to make or receive new
calls.
Intercom Allows users to place and receive intercom
calls using programmable phone buttons. You
can configure intercom line buttons to:
•
•
Note
Join Allows user to join two or more calls that are
on one line to crate a conference call and
(SCCP phones
remain on the call.
only)
Log out of hunt Allows users to log out of a hunt group and
groups temporarily block calls from ringing their
phone when they are not available to take
calls. Logging out of hunt groups does not
prevent non-hunt group calls from ringing
their phone.
Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 6.0
5-10
Directly dial a specific intercom
extension.
Initiate an intercom call and then prompt
the user to enter a valid intercom number.
Cisco Extension Mobility does not
support intercom lines.
Chapter 5 Configuring Features, Templates, Services, and Users
Configuration Reference
For more information, refer to:
Cisco Communications
•
Manager Administration
Guide, "Hunt Group
Configuration" chapter.
• Cisco Communications
Manager System Guide,
"Understanding Route
Plans" chapter.
For more information, refer to
the Unified Communications
Manager Features and Services
Guide, "Immediate Diver"
chapter.
Cisco Unified Communications
Manager Feature and Services
Guide, "Intercom chapter"
For more information:
See the "Configuring
•
Softkey Templates" section
on page 5-18.
Refer to Cisco
•
Unified Communications
Manager System Guide,
"Cisco Unified IP Phones"
chapter.
For more information
• See the "Configuring
Softkey Templates" section
on p.
Cisco Communications
•
Manager System Guide,
"Understanding Route
Plans" chapter.
OL-12650-01