Cisco 7965G Administration Manual page 115

Chapter 5 Configuring Features, Templates, Services, and Users
Table 5-1 Telephony Features for the Cisco Unified IP Phone (continued)
Feature Description
Fast Dial Service Allows a user to enter a Fast Dial code to
place a call. Fast Dial codes can be assigned
to phone numbers or Personal Address Book
entries. (See
Forced Controls the types of calls that certain users
authorization codes can place.
(FAC)
(SCCP phones
only)
Group call pickup Allows a user to answer a call ringing on a
phone in another group by using a group
pickup code.
Hold Allows the user to move a connected call from
an active state to a held state.
Hold Reversion Limits the amount of time that a call can be on
hold before reverting back to the phone that
put the call on hold and alerting the user.
Reverting calls are distinguished from
incoming calls by a single ring (or beep,
depending on the new call indicator setting for
the line). This notification repeats at intervals
if not resumed.
A call that triggers Hold Reversion also
displays an animated icon in the call bubble
and a brief message on the status line.
You can configure call focus priority to favor
incoming or reverting calls.
OL-12650-01
"Services" in this table.)
Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 6.0
Telephony Features Available for the Phone
Configuration Reference
For more information, refer to:
Cisco Unified
•
Communications Manager
Administration Guide,
"Cisco Unified IP Phone
Services Configuration"
chapter.
Cisco Unified
•
Communications Manager
System Guide, "Cisco
Unified IP Phone Services"
chapter.
For more information, refer to
the Cisco
Unified Communications
Manager Features and Services
Guide, "Client Matter Codes and
Forced Authorization Codes"
chapter.
For more information, refer to
the Cisco Unified
Communications Manager
Features and Services Guide,
"Call Pickup Group" chapter.
Requires no configuration,
•
unless you want to use music
on hold. See
"Music-on-Hold" in this
table for information.
See also: "Hold Reversion"
•
in this table.
For more information about
configuring this feature, refer to
Cisco Unified Communications
Manager Features and Services
Guide, "Hold Reversion"
chapter.
5-9