Cisco 7000 Series Configuration Manual page 49

Chapter 6 Administration
Procedure
Step 1 From the IP camera user interface, click the Setup link.
Step 2 Click Administration to expand the menu.
Step 3 From the Administration menu, click Maintenance.
The Maintenance window appears. If you change any options in this window, you must click the Save
Settings button to save the changes. If you do not click this button, changes are not retained when you
exit the window. Save Settings appears at the bottom of the window. You may need to scroll down to it.
Table 6-3
Table 6-3
Option
Factory Default Area
Restore button
Reset button
Reboot Area
Reboot button
Device Configuration Area
Export Configuration
from Camera
OL-28694-01
describes the options in the Maintenance window.
Maintenance Window Options
Description
Click the Restore button to reset all IP camera settings to their factory
default values.
To confirm the restore procedure, click OK in the confirmation pop-up
window. Otherwise, click Cancel.
This action has the same effect as pressing and holding the Reset button on
the IP camera for at least 15 seconds. After you perform this procedure,
follow the steps in the
Camera."
Click the Reset button to reset all IP camera settings except the static IP
address, gateway IP address, and log in credentials (user name and
password) to their factory default values.
To confirm the restore procedure, click OK in the confirmation pop-up
window. Otherwise, click Cancel.
Click the Reboot button to reboot the software on IP camera.
To confirm the reboot procedure, click OK in the confirmation pop-up
window. Otherwise, click Cancel.
This action has the same effect as pressing and immediately releasing the
Reset button on the IP camera, or powering the IP camera down and then
powering it up.
Click the Export button to save the current IP camera configuration
information to a binary file.
When you click this button, the File Download window appears. Use this
window to save the configuration file.
You can then load this configuration information to any same-model IP
camera in the network. This feature is useful for creating a backup of this
configuration and for configuring other IP cameras based on this
configuration.
Cisco Video Surveillance 7000 Series IP Camera Configuration Guide, Release 1.1.4
Chapter 2, "Performing the Initial Setup of the IP
Maintenance Window
6-5