Ip Filter Window - Cisco 7000 Series Configuration Manual

Chapter 5 Network Setup
The IP Filter window appears. If you change any options in this window, you must click the Save
Settings button to save the changes. If you do not click this button, changes are not retained when you
exit the window. Save Settings appears at the bottom of the window. You may need to scroll down to it.
Table 5-5
Table 5-5
Option
IP Filter Area
Enable IP Filtering
Filter Entries Area
#
Action
IP Address/Bit Mask
QoS Window
The QoS window provides options for configuring quality of service (QoS) settings for video streams.
To display the QoS window, perform the following steps:
Procedure
From the IP camera user interface, click the Setup link.
Step 1
Click Network Setup to expand the menu.
Step 2
From the Network Setup menu, click QoS.
Step 3
The QoS window appears. If you change any options in this window, you must click the Save Settings
button to save the changes. If you do not click this button, changes are not retained when you exit the
window. Save Settings appears at the bottom of the window. You may need to scroll down to it.
Table 5-6
OL-28694-01
describes the options in the IP Filter window.
IP Filter Window Options
Description
Check this check box to cause the IP camera to allow or deny access to IP
addresses as configured in the IP Filtering window.
Display only. Filter number.
Choose an action for the corresponding IP address or address range:
• Deny—IP address or address range cannot access the IP camera.
• Allow—IP address or address range can access the IP camera.
Enter the IP address and bit mask to which the corresponding action applies.
Make these entries in Classless Inter-Domain Routing (CIDR) notation.
CIDR is defined in RFC 4632.
describes the options in the QoS window.
Cisco Video Surveillance 7000 Series IP Camera Configuration Guide, Release 1.1.4
QoS Window
5-7