Advertisement
CAUTION:
Always be sure that the tool is switched off and unplugged before installing or removing the side
grip, bit or other accessories.
Installing the side grip
Always install the side grip on the tool and
hold the tool firmly with both hands during
operation.
The
side grip swings around to
either side, allowing easy handling of the tool
in any position. Swing it to the desired position
and secure it by turning clockwise.
NOTE:
The side grip cannot swing 360" when the depth gauge is installed.
Installing or removing driver bit or drill bit
CAUTl ON :
Always be sure that the tool is switched off and unplugged before installing or removing the bit.
For Model HPI 501
Hold the ring and turn the sleeve counter-
clockwise to open the chuck jaws. Place the
bit in the chuck as far as it will go. Hold the
ring firmly and turn the sleeve clockwise to
tighten the chuck.
To remove the bit, hold the ring and turn the
sleeve counterclockwise.
For Model HPI 200 and HPI 500
To install the bit, place it in the chuck as far as
it
will go.
Tighten the chuck by hand. Place the
chuck key in each of the three holes and
tighten clockwise. Be sure to tighten all three
chuck holes evenly.
To remove the bit, turn the chuck key counter-
clockwise in just one hole, then loosen the
chuck by hand.
After using the chuck key, be sure to return it
to the original position.
.Chuck key
5
Advertisement
