Figure 3-3 Setting The Ip Network Settings Automatically Or Manually - Honeywell HCD5HIH Reference Manual

Document 800-07067V5 Rev A
07/2013
®
HCD5 equIP Series True Day/Night Network Box Camera Reference Guide
Figure 3-3 Setting the IP Network Settings Automatically or Manually
Note All examples in this User Guide show the GUI for the HCD5MIH(X) model
camera, unless otherwise specified.
Updating IP Network Settings Automatically
1. In the Discovery pane, select the device and click Connect
2. From the System tab click the Obtain an IP Address automatically check box.
3. Enter a Device Name, for example,
4. Click Apply.
The network automatically assigns the IP Address based on the DHCP network server
details. If no DHCP server is present on the network, the hardware defaults to an
APIPA address (169.254.x.x).
Updating IP Network Settings Manually
Caution When manually updating the network settings, it is important to enter
the correct IP network settings before applying them. Incorrect values
might cause a failure when connecting to the device. See
for definitions of each setting.
1. In the Discovery pane, select the device, and click Connect
2. To assign a static IP address to the device, from the System tab click to clear the
Obtain an IP Address automatically check box.
3. Enter a Device Name, for example, FrontLobby01.
Click to clear this checkbox and
manually set the network details
FrontLobbyCam01.
.
Table 3-3
.
33