Table of Contents
Advertisement
When discharging into a standpipe ensure that the top of
the standpipe is no more than 90 cm (35.4'') and no less
than 60 cm (23.6'') above floor level.
The drain hose may be extended to a maximum of 4 me-
tres. An additional drain hose and joining piece is avail-
able from your local Service Force Centre. The joining
piece must have an internal diameter of 18 mm.
If your drain hose looks like this (see below) you do not
require the "U" piece". Just push the hose firmly in to the
standpipe.
2. Onto a sink outlet spigot.
If the outlet spigot has not been used before, remove any
blanking plug that may be in place.
30
3 pin
Push the drain hose onto the spigot and secure with a
clip, ensure a loop is formed in the drain hose (see dia-
gram) to prevent waste from the sink entering the appli-
ance.
If you intend to drain the hose from the machine into a
sink, make sure that the sink is empty and the plug hole
is not blocked.
Use the plastic "U - Piece" supplied.
Advertisement
Table of Contents
