Table of Contents
Advertisement
structions. This will help to prevent the formation of lime
deposits.
After each wash
Leave the door open for a while. This helps to prevent
mould and stagnant smells forming inside the appliance.
Keeping the door open after a wash will also help to pre-
serve the door seal.
Maintenance wash
With the use of low temperature washes it is possible to
get a build up of residues inside the drum.
We recommend that a maintenance wash be performed
on a regular basis.
To run a maintenance wash:
• The drum should be empty of laundry.
• Select the hottest cotton wash programme.
• Use a normal measure of detergent, must be a powder
with biological properties.
External cleaning
Clean the exterior cabinet of the appliance with soap and
water only, and then dry thoroughly.
Important! Do not use methylated spirits, solvents or
similar products to clean the cabinet.
Cleaning the dispenser drawer
The detergent dispenser drawer should be cleaned regu-
larly.
The washing powder and additive dispenser drawer
should be cleaned regularly.
Remove the drawer by pressing the catch downwards and
by pulling it out.
Flush it out under a tap, to remove any traces of accu-
mulated powder.
To aid cleaning, the top part of the additive compartment
should be removed. Clean all parts with water.
Clean the chamber of dispenser drawer with a brush.
Washing drum
Rust deposits in the drum may occur due to rusting for-
eign bodies in the washing or tap water containing iron.
Important! Do not clean the drum with acidic descaling
agents, scouring agents containing chlorine or iron or
steel wool.
1. Remove any rust deposits on the drum with a cleaning
agent for stainless steel.
2. Run a washing cycle without any washing to clean off
any cleaning agent residues.
19
Advertisement
Table of Contents
