Zanussi ZWD 14791 W User Manual page 21

Warning!
When the appliance is in use and depending on the pro-
gramme selected there can be hot water in the pump.
Never remove the pump cover during a wash cycle, always
wait until the appliance has finished the cycle, and is
empty. When replacing the cover, ensure it is securely
retightened so as to stop leaks and young children being
able to remove it.
Cleaning the water inlet filter
If you notice that the machine is taking longer to fill, check
that the filter in the water inlet hose is not blocked.
1. Turn off the water tap.
2. Unscrew the hose from the tap.
3. Clean the filter in the hose with a stiff brush.
4. Screw the hose back onto the tap.
Emergency emptying out
If the water is not discharged, proceed as follows to empty
out the machine:
1. pull out the plug from the power socket;
2. close the water tap;
3. if necessary, wait until the water has cooled down;
4. open the pump door;
5. place a bowl on the floor and place the end of the
emergency emptying hose into the bowl. Remove its
cap. The water should drain by gravity into the bowl.
When the bowl is full, put the cap back on the hose.
Empty the bowl. Repeat the procedure until water
stops flowing out;
6. clean the pump if necessary as previously described;
7. replace the emergency emptying hose in its seat after
having plugged it;
8. screw the pump again and close the door.
Frost precautions
If the machine is installed in a place where the temperature
could drop below 0°C, proceed as follows:
1. Turn off the water tap.
2. Unscrew the inlet hose.
3. Place the end of the emergency emptying hose and
that of the inlet hose in a bowl placed on the floor and
let water drain out.
4. Screw the water inlet hose back on and reposition the
emergency emptying hose after having put the cap
on again.
5. When you intend to start the machine up again, make
sure that the room temperature is above 0°C.
21