Table of Contents
Advertisement
to O . After a few minutes the door can be opened (pay
attention to the water level and temperature!) .
After closing the door, it is necessary to select the pro-
gramme and options again and to press button 8 .
At the end of the programme
The machine stops automatically. Three blinking 0.00
appear on the display and the pilot light of button 8 goes
off. Some acoustic signals sound for a few minutes.
If a programme or an option that ends with water left in
the tub has been selected, the door remains locked to
indicate that the water must be emptied out before opening
the door.
Follow the below instructions to empty out the water:
1. Turn the programme selector dial to O .
2. Select the draining or spinning programme.
3. Reduce the spin speed if needed, by pressing the
relevant button.
Use - Drying
Drying only
Warning!
The recommended load size is 4 kg for cottons and linen,
and 3 kg for synthetic items.
By pressing Drying Time button it is also possible
to dry up to 6 kg of cotton items (see the «Drying
Programme » table).
Warning!
The water tap must be open and the drain hose must be
positioned in the sink or connected to the drain pipe.
1. Load the laundry.
2. Select a spin cycle at the maximum spin speed al-
lowed for the type of laundry in order to obtain the
best drying performances.
3. Select the drying programme for Cottons or Synthetic
in the Drying sector of the programme selector dial.
4. If you wish to select an electronic drying, depress the
button 4 until the icon corresponding to the required
dryness degree appears on the display, marked with
.
the icon
5. If you wish to select a timed drying, press button 5
until the time you want appears on the display (see
the «Drying Programme» table). Every time you
10
4. Press button 8 .
At the end of the programme, turn the programme selector
dial to O to switch the machine off.
Remove the laundry from the drum and carefully check
that the drum is empty. If you do not intend to carry out
another wash, close the water tap. Leave the door open to
prevent the formation of mildew and unpleasant smells.
Stand By : If your laundry is not removed within 10 mi-
nutes after the programme is finished, the back light of
the display switches off and the energy saving system will
be enabled. Only the pilot light of the button 8 is blinking
to indicate that the appliance has to be switched off. By
pressing any button the appliance will come out from the
energy saving status and you can set another programme
or switch the appliance off.
press this button the drying time increases by 5 mi-
nutes.
Note!
The programme time will automatically increase by
some minutes.
6. Press button 8 to start the programme.
After the programme has started, the time remaining
is updated every minute.
Note!
The different type of cottons (towelling, sheets, shirts,
and so on) or any laundry items rolling up during the
spinning phase may result in partial dryness. In the
exceptional case that at the end of the cycle the laun-
dry remains slightly wet, we suggest that you unfold
the rolled up items, redistribute them evenly in the
drum and select an additional drying cycle of 20-30
minutes.
7. At the end of the programme, the buzzer sounds and
three blinking « 0.00 » appear on the display and the
door is locked.
The last 10 minutes of the drying cycle correspond
to an anti-crease phase. During this time the door is
locked and the display keeps showing three flashing
zeros « 0.00 ».
Advertisement
Table of Contents
