Table of Contents
Advertisement
3. Set the hose correctly by loosening the ring nut. After
positioning the inlet hose, be sure to tighten the ring
nut again to prevent leaks.
The inlet hose must not be lengthened. If it is too short
and you do not wish to move the tap, you will have to
purchase a new, longer hose specially designed for this
type of use.
Important! Before connecting up the machine to new
pipework or to pipework that has not been used for some
time, run off a reasonable amount of water to flush out
any debris that may have collected in the pipes.
Warning! Installation should comply with local
water authority and building regulations'
requirements.
The appliance must be connected to a cold water supply.
A minimum water pressure of 0.05 MPa (0.5 bar) is
required for safe operation of the appliance.
If you cannot make the cold water connection direct from
the rising mains, you may be able to operate the appliance
from your cold water storage system.
There should be a minimum vertical distance of 5.02 m
(16.5 ft) between the appliance's inlet and the bottom of
the water storage tank.
Water drainage
This appliance is designed to be permanently plumbed
into your home's drainage system using one of the fol-
lowing methods.
1. Into a drainage standpipe
Firstly form a hook in the end of the drain hose using the
"U" piece" supplied.
"U" piece
supplied
Place the drain hose into your standpipe, which should
have an internal diameter of approximately 38 mm thus
ensuring there is an air break between the drain hose and
standpipe.
38 mm (½")
standpipe
diameter
29
Advertisement
Table of Contents
