Assigning An Ip Address Using The Cli - Cisco Aironet 1130AG Quick Start Manual

Assigning an IP Address Using the CLI

When you connect the access point to the wired LAN, the access point links
to the network using a bridge virtual interface (BVI) that it creates
automatically. Instead of tracking separate IP addresses for the access point's
Ethernet and radio ports, the network uses the BVI.
When you assign an IP address to the access point using the CLI, you must
assign the address to the BVI. Beginning in a privileged EXEC mode, follow
these steps to assign an IP address to the access point's BVI:
Command
Step 1
configure terminal
Step 2 Interface bvi1
Step 3
ip address address mask Assigns an IP address and subnet mask
Quick Start Guide Cisco Aironet 1130AG Access Point
Purpose
Enter global configuration mode.
Enters interface configuration mode
for the BVI.
address to the BVI.
17