Resetting To Default Configuration; Using The Mode Button - Cisco Aironet 1130AG Quick Start Manual

If a wireless client cannot authenticate with your access point, contact the
system administrator for proper security settings in the client adapter and for
the client adapter driver and firmware versions that are compatible with the
access point settings.

Resetting to Default Configuration

If you forget your password that allows you to configure the access point, you
may need to completely reset the configuration. You can use the MODE
button on the access point to reset the configuration.
Note
These steps reset all configuration settings to factory defaults,
including passwords, WEP keys, the IP address, and the SSID.

Using the MODE Button

Follow these steps to delete the current configuration and return all access
point settings to the factory defaults by using the MODE button:
1. Open the access point cover (refer to the "How to Open the Top Cover"
section on page 2).
2. Disconnect power from the access point (the power jack for external
power or the Ethernet cable for in-line power).
Quick Start Guide Cisco Aironet 1130AG Access Point
43