Assigning An Ip Address Using The Cli - Cisco 1240AG Series Quick Start Manual

Note The Cisco part number for the serial cable is
AIR-CONCAB1200.
2. Set up a terminal emulator on your PC to communicate with the access
point. Use the following settings for the terminal emulator connection:
9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.

Assigning an IP Address Using the CLI

When you assign an IP address to the access point by using the CLI, you must
assign the address to the BVI. Beginning in a privileged EXEC mode, follow
these steps to assign an IP address to the access point BVI using the access
point console port.:
Command
Step 1
configure terminal
Step 2 Interface bvi1
Step 3
ip address address mask Assigns an IP address and subnet mask
20
Purpose
Enter global configuration mode.
Enters interface configuration mode
for the BVI.
address to the BVI.
OL-16714-01