Compliance Information - Cisco Aironet 1130AG Quick Start Manual

7. Click the Reset to Defaults button.
Note If the access point is configured with a static IP address, the IP
address does not change.
8. After the access point reboots, you must reconfigure it.

Compliance Information

This equipment has been tested and found to comply with the European
Telecommunications Standard ETS 300.328. This standard covers Wideband
Data Transmission Systems referred to in CEPT recommendation T/R 10.01.
This type-accepted equipment is designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed in accordance with the instruction
manual, may cause harmful interference to radio communications.
The Declarations of Compliance for this product relevant to the European
Union and other countries following EU Directive 1999/5/EC (R&TTE
Directive) can be found in the Cisco Aironet 1130AG Series Access Point
Hardware Installation Guide. This guide is available on Cisco.com.
Quick Start Guide Cisco Aironet 1130AG Access Point
45