Table of Contents
Advertisement
CAUTION
any time in a dynamic IP environment.
Tamper Event Settings
You can set how to react upon a detected tampering event. To set the tampering event detection
in for each channel, see
1.
2.
Note
If the DDNS address fails to be updated, the DVR may not connect to a
remote client. If this is the case, enter the IP address from the client side
to allow access from the DVR. This is just a temporary measure.
For the IP address, move to and check EXTERNAL IP ADDRESS from
the NETWORK window. Note that the EXTERNAL IP ADDRESS is
subject to change if the DVR does not use the static IP.
Note that the EXTERNAL IP ADDRESS can change at
Figure 4-57
Network System Event Settings
Tamper Detection on page
From SYSTEM SETUP
Use
,
,
, and
buttons on the remote or the mouse to set the detection interval and
its action.
62.
EVENT, select TAMPER EVENT (see
System Setup | 103
Figure
4-58).
800-15802 - A - 12/2013
Advertisement
Table of Contents
