Horizon Fitness FS 40 Assembly And User's Manual page 7

A S SE M B LY ST EP 
HARDWARE BAG  CONTENTS :
BOLT (I) FLAT WASHER (J)
Qty: 4 Qty: 8
FLAT WASHER (J)
NYLON NUT (K)
A Open HARDWARE BAG .
B Install 2 BOLTS (I), 4 FLAT WASHERS (j) and 2 NYLON NUTS (K) into the BASE FRAME as
shown in diagram.
C Insert each GUIDE ROD into the BASE FRAME as shown in diagram.
D Install rubber BUMPER onto each GUIDE ROD.
E Install each WEIGHT PLATE onto GUIDE RODS
NOTE: Ensure that each WEIGHT PLATE's selector pin slot faces downward.
F Insert each GUIDE ROD into the corresponding hole in the UPPER PULLEY ASSEMBLY.
G Secure GUIDE RODS in UPPER PULLEY ASSEMBLY using 2 BOLTS (I), 4 FLAT WASHERS (j)
and 2 NYLON NUTS (K).
NOTE: Ensure that each bolt is inserted through the hole at the top of the GUIDE ROD.
H Tighten all hardware.
12
FS 40 rev 1.0.indd 12-13
NYLON NUT (K) BUMPER
Qty: 4 Qty: 2
GUIDE ROD
TOP WEIGHT
BAYONET
WEIGHT PLATE
SELECTOR PIN
BUMPER
SCREW (I)
FLAT WASHER (J)
ASSEMBLY STEP 
HARDWARE BAG  CONTENTS :
CABLE A
Qty: 1
NYLON NUT (C)
FLAT WASHER (B)
BALL
RUBBER STOP
CLEVIS
FLAT WASHER (B)
SCREW (E)
CABLE A
HOOK
LAT BAR
DUAL FLOATING
PULLEY BRACKET
LAT BAR / WEIGHT
CABLE SCREW AND NUT
TOP WEIGHT
THREAD
A Open HARDWARE BAG .
B Remove nylon nut and threaded
screw from end of CABLE A.
C Insert cable end into LAT BAR
ASSEMBLY BRACKET pulley as
shown in diagram.
NOTE: After passing through
second pulley bracket, DUAL
FLOATING PULLEY BRACKET
must be installed.
D Re-install threaded screw and
nylon nut before threading
cable into TOP WEIGHT PLATE.
NOTE: Always maintain at least
½˝ of weight cable screw in
TOP WEIGHT PLATE for saftey.
E Hook LAT BAR on to cable using
the HOOK and rest in craddle.
1
8/20/07 11:37:10 AM