Horizon Fitness FS 40 Assembly And User's Manual page 5

AS SE MB LY S TE P 2
HARDWARE BAG 1 CONTENTS :
BOLT (A)
Qty: 4
BOLT (D)
Qty: 2
FLAT WASHER (B)
NYLON NUT (C)
BOLT (D)
FLAT WASHER (B)
LAT BAR
BRACKET ASSEMBLY
FLAT WASHER (B)
NYLON NUT (C)

FS 40 rev 1.0.indd 8-9
FLAT WASHER (B) NYLON NUT (C)
Qty: 12 Qty: 6
SUPPORT PLATE
Qty: 2
A Open HARDWARE BAG 1.
UPPER PULLEY ASSEMBLY
B Attach UPPER PULLEY
ASSEMBLY to CENTER
SUPPORT FRAME using 2
BOLTS (D), 4 FLAT WASHERS
(B) and 2 NYLON NUTS (C).
Tighten this hardware.
C Position LAT BAR BRACKET
ASSEMBLY in line with the
UPPER PULLEY ASSEMBLY
and the LEFT SUPPORT
FRAME and RIGHT SUPPORT
FRAME as shown. Using 4
BOLTS (A), 8 FLAT WASHERS
(B) and 4 NYLON NUTS (C)
attach SUPPORT PLATES, LAT
FLAT WASHER (B)
BAR BRACKET ASSEMBLY and
UPPER PULLEY ASSEMBLY to
BOLT (A)
the LEFT SUPPORT FRAME and
RIGHT SUPPORT FRAME as
shown.
SUPPORT
PLATE
ASSEMBLY STEP 
HARDWARE BAG 2 CONTENTS :
BOLT (A) FLAT WASHER (B)
Qty: 2 Qty: 4
FRONT COVER
FLAT WASHER (B)
BOLT (A)
SEAT WELDMENT SET
STEP -D: INSTALLING THE STOPPER:
A Open HARDWARE BAG 2.
B Attach SEAT WELDMENT SET.
C Attach COVER to bolted joint using 4 SCREWS (F).
D Remove STOPPER from front side of RADIAL ARM ASSEMBLY and reinstall on back side of
RADIAL ARM ASSMBLY.
E Attach RADIAL ARM ASSEMBLY to CENTER SUPPORT FRAME using 2 BOLTS (A), 4 FLAT
WASHERS (B) and 2 NYLON NUTS (C).
NYLON NUT (C) SCREW (F)
Qty: 2 Qty: 4
SCREW (F)
BACK COVER
FLAT WASHER (B)
NYLON NUT (C)
RADIAL ARM ASSEMBLY
RADIAL ARM ASSEMBLY
STOPPER

8/20/07 11:37:01 AM