Assembly Step - Horizon Fitness FS 40 Assembly And User's Manual

CABLE "A"
LAT PULLDOWN BAR
LAT BAR BRACKET ASSEMBLY
CENTER SUPPORT FRAME
MAIN SUPPORT FRAME (RIGHT)
CABLE "C"
RADIAL ARM ADJUSTMENT PIN
SEAT BACK PAD
SEAT BOTTOM PAD
SEAT ASSEMBLY
SEAT HEIGHT ADJUSTMENT KNOB
FOAM LEGROLLERS
ADJUSTABLE FOOTPLATE
TOOLS INCLUDED
Screwdriver
19 mm Flat Wrench
13 mm/17 mm Flat Wrench
PARTS INCLUDED
1 Seat Assembly Safety Pin
2 Foam Rollers
1 Seat Back Cushion
1 Main Base Frame
1 Main Support Frame (Right)
1 Main Support Frame (Left)
1 Radial Arm Assembly
If you have questions or if there are any missing parts, contact Customer Tech Support.
Contact information is located on the back panel of this manual.
For a complete exploded diagram, visit us at www.horizonfitness.com

FS 40 rev 1.0.indd 6-7
UPPER PULLEY ASSEMBLY
DUAL FLOATING PULLEY BRACKET
RADIAL ARM ASSEMBLY
WEIGHT SELECTION PIN
MAIN SUPPORT FRAME (LEFT)
SINGLE FLOATING PULLEY BRACKET
SEAT ASSEMBLY SAFETY PIN
4 mm Allen Wrench
6 mm Allen Wrench
8 mm Allen Wrench
1 Center Upright 1 Single Floating Pulley Bracket
1 Seat Assembly 1 Upper Pulley Assembly
(Multiple Pulleys)
3 Weight Shields
3 Cables
2 Guide Rods
1 Weight Selection Pin
1 Upper Pulley Bracket
1 Dual Floating Pulley Bracket
PRE-ASSEMBLY
NOTE:
During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before
completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware.
Any grease, such as lithium bike grease is recommended.
WEIGHT SHIELD

ASSEMBLY STEP 1

GUIDE ROD
BASE FRAME
CENTER SUPPORT
FRAME
CABLE "B"
A Place BASE FRAME on floor in
MAIN SUPPORT
desired location.
FRAME (RIGHT)
B Remove 6 NYLON NUTS (C)
and 6 FLAT WASHERS (B) from
BASE FRAME.
C Attach RIGHT MAIN SUPPORT
FRAME to right side of BASE
FRAME using 2 BOLTS (A),
MAIN SUPPORT
2 FLAT WASHERS (B) and 2
FRAME (LEFT)
NYLON NUTS (C).
D Repeat on other side.
NYLON NUT (C)
E Attach CENTER SUPPORT
FLAT WASHER (B)
FRAME to BASE FRAME using
2 BOLTS (A), 2 FLAT WASHERS
(B) and 2 NYLON NUTS (C).
BASE FRAME

8/20/07 11:36:57 AM