Mode Transitions - Honeywell DCP552 Mark II User Manual

Chapter 5. FUNCTIONS

Mode transitions

Program operation
END AUTO
END MANUAL
Constant value control
Switching between program operation and constant value control
5-26
Mode transitions are indicated by the solid line arrows and end operation is
indicated by the dashed lines in the figure below.
RESET READY AUTO
READY MANUAL
RESET
FAST
READY FAST AUTO
READY FAST MANUAL
NOTE
•AUTO ↔ MANUAL mode changes can be made in the boxes of each mode.
•READY and END at the end of operation can be selected using setup data
C31.
•CH1 and CH2 mode transitions can be performed both synchronously or
asynchronously.
Mode transitions are indicated by the solid line arrows.
READY AUTO
READY MANUAL
NOTE
•AUTO ↔ MANUAL mode changes can be made in the boxes of each mode.
•CH1 and CH2 mode transitions can be performed both synchronously or
asynchronously.
Constant value control data "ConSt " control mode item in the READY mode is
used to switch between these two modes.
0: Program operation
1: Constant value control
ADV
RESET
RUN
RUN AUTO
RESET
RUN MANUAL
FAST
RUN
RUN
RESET
ADV
RUN
RUN AUTO
RESET
RUN MANUAL
ADV
HOLD
HOLD AUTO
RUN
HOLD MANUAL
FAST
HOLD
FAST AUTO
FAST MANUAL
ADV
ADV