Setting The Clock; Purpose; Procedure; Table 5-7 Procedure For Setting The Clock - Honeywell 9782 Series Operator's Manual

5.7 Setting the Clock

Purpose

A display showing the current time can be accessed when the unit is online. The 24-hour clock
must be set before you can use the AutoClean feature described in Sub-Section 5.6.

Procedure

Follow the procedure in Table 5-7 to set the 24-hour clock.
Step
MENU
1
CONFIGURATION
CALIBRATION
MAINTENANCE
I/O SETUP
DIAGNOSTICS
| PREV |
CONFIGURATION
CAT/RETRANSMISSION
ALARMS
DISCRETE CONTROL
ADVANCED FEATURES
DIAGNOSTICS
| PREV |
ADVANCED FEATURES
CLOCK SETUP
COMPUTED VALUE
AUTO CLEAN
DIAGNOSTICS
|
2 24 HOUR CLOCK SETUP
CLOCK
HOURS
MINUTES
DIAGNOSTICS
|
7/99 9782 Series Conductivity/Resistivity Analyzer/Controller - Operator's Manual

Table 5-7 Procedure for Setting the Clock

Screen
Go to CONFIGURATION | ADVANCED FEATURES |
CLOCK SETUP.
NEXT
NEXT
|
Set the clock. For example, if you will start the clock at
1:30 PM, enter 13 hours, 30 minutes.
OFF
13
30
Start the clock and specify what should happen to the
clock if the power fails.
| NEXT
Display of "RESET CLOCK" will continue until you either
reset the clock or turn it off.
I/O Setup and System Configuration
ON W/RESET starts the clock now. Following power
failure, the clock will be reset to 00:00 and the diagnostic
message "RESET CLOCK" will be displayed.
ON W/O RESET starts the clock now. Following power
failure the clock will remain off, and the diagnostic
message "RESET CLOCK" will be displayed.
Action
5-17