Honda H5518 Operator's Manual page 56

Deep cut
1. Cutting height too low
) Increase to proper height.
2. Tractor speed too high
e Lower to proper speed.
3. Uneven surface
) Change cutting pattern.
4. Rough and uneven surface
-Adjust with height adjuster
(see page 33).
Excessive vibration
1. Unbalanced blades
e Adjust balance.
2. Drive/blade belt damaged
w Replace.
3. Pulley (s) damaged or out of -
See your authorized Honda
alignment
tractor dealer.
Engine speed drops excessively under loads.
1. Engine speed too low
) Run at full throttle.
2. Tractor speed too fast ) Lower to proper speed range.
3. Pebbles or other foreign matter - Remove.
are stuck in cutter deck.
54