Table of Contents
Advertisement
5. Installation
of driven
pulley
Remove
and retain driven pulley (MM46Kl)
on the cutter deck by remov-
ing the
10 x 16 mm flange
bolt and 10.5
x 27 mm washer.
Install the
driven
pulley
(MK4618)
using the original bolt and washer.
Tighten
the bolt to the specified
torque.
Torque
specification:
4.0
kg-m (28.9
ft-lb)
6. Installation
of cutter
deck
H Cutter
deck assembly
-
1. Install
the discharge
cover
using two
flange
nuts; tighten
nuts to
specified
torque:
Torque
specification:
2.2
kg-m (16 ft-lb)
FLANGE
NUTS
-
2.
18
DISCHARGE
Remove
the front link adjust pins and install the new front link adjust
pins included
with the MK4618
kit. Adjust
the length
of the cutter
deck lift plates to 150-
152 mm (5.9-6.0
in.), then tighten
the nuts
securely.
Install the cutter deck lift plates on the cutter deck with 14
mm plain washers
and linch pins.
Install
the
rear deck
links
on the
cutter
deck
with
14 mm plain
washers
and lock pins (gold).
CUTTER
DECK LIFT PLATE
4 mm PLAIN WASHER
REAR DECK LINK
PLAIN WASHER
Hide quick links:
Advertisement
Table of Contents
