Honda H5518 Operator's Manual page 29

9. Adjustment of cutter deck lift link
n
Cutter deck lift plate
-
1. Place the tractor on a firm, level surface. Apply and lock the parking
brake.
- 2. Start the engine, move the hydraulic cylinder selector lever (optional
part) to "FRONT",
and raise the cutter deck fully with the hydraulic
lift lever.
- 3. Turn the descent speed adjust knob fully clockwise.
- 4. Stop the engine, and remove the key from the ignition switch.
- 5. Adjust the deck lift plates until the height of the cutter deck is equal
on both sides..
- Turn the cutter deck adjust knob counterclockwise.
- Use the hydraulic lift lever to lower the cutter deck.
- Adjust the cutter deck lift plates by loosening the lock nuts and
turning the adjust pins as needed.
- 6. After the height of the cutter deck is equal on both sides, raise the
cutter deck and turn the cutter deck descent adjust knob clockwise.
- 7. If the height of the cutter deck is less than 115 mm (4.5 in.), adjust
with the cutter deck lift rod adjust pins until the height is from 115 to
118 mm (4.5 to 4.7 in.).
LOCK NUT
ADJUST PIN
upa.
LINCH PIN
27