D-Link DCS-2100+ Manual page 21

Using & Configuring the DCS-2100+ with a
NAT Router (continued)
These are the port
settings for your camera.
They can be changed if
needed.
Router Set-Up and Installation
The following steps generally apply to any router that you have on your network.
The D-Link DI-614+ is used as an example to clarify the configuration process.
Configure the initial settings of the DI-614+ by following the steps outlined in the
DI-614+ Quick Installation Guide.
$ $ $ $ $
Access Your Router on Your Web Browser
If you have cable or DSL Internet service, you will most likely have a dynamically
assigned WAN IP Address. 'Dynamic' means that your router's IP address can
change from time to time depending on your ISP. A dynamic WAN IP Address
identifies your router on the public network and allows it to access the Internet.
To find out what your router's WAN IP Address is, go to the Status menu on
your router and locate the WAN information for your router (as shown on the
next page). The WAN IP Address will be listed. This will be the address that
you will need to type in your web browser to view your camera over the Internet.
Ports that are used by the DCS-2100+
21