D-Link DCS-2100+ Manual page 12

Software Installation (continued)
If you need to make any changes,
click Back to modify your camera
settings. To accept the settings,
click Restart.
Click Restart
Click OK and the DCS-2100+ Internet Camera will
reboot to accept the settings.
If the IP Installer has not made any modifications to
the settings, it will warn you that the settings were
accepted but no changes were made.
You should now see the opening IP Installer screen with an IP address assigned
to the MAC address of the DCS-2100+.
Click on Exit to close IP Installer.
You have now completed the Setup Wizard and are ready to use your
camera! You can also continue to the next section to install the
IP Surveillance software before you begin to use the DCS-2100+.
12