D-Link DCS-2100+ Manual page 11

Software Installation (continued)
If you have a DHCP server on your network,
you will already have a valid IP Address in
these fields.
If you do not have a DHCP server on your
network fill out your IP Address, Subnet
mask, Gateway and at least one DNS IP
Address.
If you do not know what to put in these
fields, please contact your System
Administrator or your Internet Service
Provider.
Click Next
Leave the box titled This camera can be found by installer whenever it starts up
unchecked to avoid running this install application each time you boot up the
DCS-2100+. Check this box if you need to change IP address the next time the
DCS-2100+ boots up.
Type in your SSID and Connection type con-
sistent with your network. (If you are
unsure, please contact your network
administrator).
Choose the Channel that is the same as your
other wireless devices that you would like to
connect to.
You can choose a different transmission rate
if you need to restrict the camera's bandwidth.
Select Long or Short Preamble. Long
Preamble is the default setting. See page
31 for a description of Preamble.
You can enable Encryption here (up to 256-
bit).
Click Next
11