Table of Contents
Advertisement
Installing the Honeywell IP Utility and Web Client Software
30
3.
Enter the case-sensitive password in the Password field.
•
The default Administrator password is 1234.
•
The default Guest password is guest.
Note
During the installation set up, you must log on as an Administrator to access
all the features.
4.
Click the arrow button
The Honeywell IP Utility program searches for devices on the network and opens to
the Honeywell IP Utility user interface.
5.
Automatically discover or manually refresh the list of devices on the network.
Use the manual refresh if a new device was added after you logged onto the system.
•
You do not need to do anything to discover devices. When you log on to the IP
Utility, the devices on the network — including the devices on other subnets —
are automatically discovered and listed in the Discovery pane. After the initial
discovery, the network automatically continues to discover devices that are newly
added to the network.
•
To manually refresh the device list, click the Refresh (
the top of the Discovery pane.
6.
Enable or disable the HTTP Server checkbox for additional security. Only an
Administrator can disable (uncheck the box), resulting in the user being unable to
access the web client, although video recording is unaffected.
Honeywell IP Utility interface.
Note
All examples in this User Guide show the GUI for the HCD5MIH model
camera, unless otherwise specified.
.
) button, located near
Figure 3-3
shows the
Advertisement
Table of Contents
