Wiring; Connecting Video; Figure 2-2 Camera Mount; Figure 2-3 Camera Connections - Honeywell HCD5HIH Reference Manual

Installation and Setup
Use standard size
mounting bolts (1/4 x 20)
to mount the camera on
a bracket or tripod.

Wiring

24V AC power
RJ45 Ethernet network
connection (using
10Base T or 100Base
TX cable). Also for
Power over Ethernet
(PoE 802.3 af).

Connecting Video

20
Figure 2-2 Camera Mount
Figure 2-3 Camera Connections
Caution Installation must be performed by a qualified service technician and
must be in accordance with all national and local mechanical and
electrical codes.
Spot Monitor
The analog video connection is available as a test output and should be used during
installation to aim and focus the camera as needed.
Connect the VIDEO connector on the rear of the camera to the video input connector on
your spot monitor.
Analog video connection
for a spot monitor
Alarm input (maximum rated
voltage level 24V DC) and output.
Contacts rated 12V DC @ 0.5 A.
Audio line level input and
output connections (600
Ohm impedance).