Table of Contents
Advertisement
6.
BIOS Recovery (3-pin RECOVERY1)
This jumper allows you to recover your original BIOS from a floppy disk
in case the BIOS codes and data are corrupted.
To recover the BIOS:
1. Turn OFF your computer and unplug the power cord.
2. Move the jumper cap from pins 1-2 (default) to pins 2-3.
3. Insert a floppy disk with the original or updated BIOS file.
4. Plug the power cord and turn ON the computer.
5. The system searches for the BIOS file in the floppy then reflashes
the BIOS.
6. When finished, shut down your computer.
7. Replace the jumper cap from pins 2-3 to pins 1-2.
8. Reboot your computer.
9. Hold down the <Del> key during the boot process and enter BIOS
setup to re-enter data.
KFN4-DRE BIOS Recovery Setting
7.
VGA Graphics controller setting (3-pin VGA_EN1)
This jumper allows you to enable or disable the onboard ATI ES1000
video graphics controller. Set to pins 1-2 to enable the video graphics
controller.
KFN4-DRE VGA_EN1 Setting
2-20
RECOVERY1
1 2
2 3
Normal
BIOS Recovery
(Default)
VGA_EN1
3
2
2
1
Enabled
Disabled
(Default)
Chapter 2: Hardware information
Advertisement
Table of Contents
