Rack-Mounting The Chassis - Cisco ASA 5505 Hardware Installation Manual

Chapter 3 Installing the Cisco ASA 5505
Step 9 Allowing the screws in the anchors to go through the holes in the brackets, mount and slide down the
adaptive security appliance.
Figure 3-5
1
Connect the interface cables.
Step 10
For information on installing the cables

Rack-Mounting the Chassis

To rack-mount the adaptive security appliance chassis, perform the following steps:
Step 1 Remove the three screws from the bottom of the adaptive security appliance as shown in
Discard these screws as you will not need them.
Place the wall-mount bracket on the adaptive security appliance. Use the three screws provided in the
Step 2
accessory kit to screw the wall-mount bracket to the adaptive security appliance as shown in
OL-18362-01
Mounting the Cisco ASA 5505 Chassis
Screws
, see the
"Connecting the Interface Cables"
Cisco ASA 5505 Adaptive Security Appliance Hardware Installation Guide
Rack or Wall Mounting the Cisco ASA 5505
1
section.
Figure
Figure
3-13.
3-13.
3-7