Installing An Ssc - Cisco ASA 5505 Hardware Installation Manual

Chapter 4 Maintenance and Upgrade Procedures
Table 4-1
Table 4-1
1

Installing an SSC

To install a new SSC for the first time, perform the following steps:
Power off the adaptive security appliance.
Step 1
Locate the grounding strap from the accessory kit and fasten it to your wrist so that it contacts your bare
Step 2
skin. Attach the other end to the chassis.
Remove the two screws (as shown in
Step 3
cover.
Figure 4-4
Insert the SSC into the slot opening as shown in
Step 4
Figure 4-5
Attach the screws to secure the SSC to the chassis.
Step 5
Power on the adaptive security appliance.
Step 6
Check the LEDs. If the SSC is installed properly the STATUS LED flashes green.
Step 7
Step 8 Connect one end of the RJ-45 cable to the port and the other end of the cable to your network devices.
OL-18362-01
describes the SSC LEDs.
SSC LEDs
LED Color State
STATUS Green Flashing
Solid
Removing the Screws from the Slot Cover
PO W ER
48
VD C
7
PO W ER
ov er ET
HE RN ET
6
Inserting the SSC into the Slot
C i
sc
o S
A
A S
S
C -05
S T T
A US
Description
The system is booting.
The system has passed power-up diagnostics.
Figure 4-4) at the left rear end of the chassis, and remove the slot
Se cu rit
y
Se rv ic es
Ca rd Sl
ot
C on so le
5
4
1
3
2
1
0 2
Figure 4-5.
P O W E R
48
VD C
7
PO W ER
ov er ET
HE RN ET
6
Cisco ASA 5505 Adaptive Security Appliance Hardware Installation Guide
Installing and Replacing the SSC
RE SE T
Se cu rit
y
Se rv ic es
C ar d Sl
ot
5
4
3
2
1
0
C on so le
1
2
R ES ET
4-5