Operation - Makita 4334D Instruction Manual

1
2
1. Vacuum head
2. Base

OPERATION

1
1. Cutting line
2. Base
1
1. Base securing lever
To attach the vacuum head on the tool, insert the hooks of the vacuum head
002741
into the hole in the base. The vacuum head can be installed on either left or
right side of the base.
Then connect a Makita vacuum cleaner to the vacuum head.
002742
CAUTION:
• Always hold the base flush with the workpiece. Failure to do so may
cause blade breakage, resulting in a serious injury.
• Advance the tool very slowly when cutting curves or scrolling. Forcing the
tool may cause a slanted cutting surface and blade breakage.
Turn the tool on without the blade making any contact and wait until the blade
002745
attains full speed. Then rest the base flat on the workpiece and gently move
the tool forward along the previously marked cutting line.
NOTE:
• If the tool is operated continuously until the battery cartridge has
discharged, allow the tool to rest for 15 minutes before proceeding with a
2
fresh battery.
Bevel cutting
002754
CAUTION:
• Always be sure that the tool is switched off and the battery cartridge is
removed before tilting the base.
With the base tilted, you can make bevel cuts at any angle between 0° and 45°
(left or right).
Loosen the base securing lever and move the base so that the dent mark in
the motor housing is aligned with the slot in the base.
11