Frameless Cabinets - GE ZET1 Installation Instructions Manual

Cabin
Per Warm-
ing Drawer
Requirement
Single Oven Cutout
for Installation Over
a Monogram Warming
Drawer
Double Oven Cutout
for Installation Over
a Monogram Warming
Drawer
Anti-Tip Block Against
Rear Wall Per Warming
Drawer Requirement
2" (5.1 cm) Min,
NOTE: Instoll t he
oven only with spe-
cific models listed on
the label located on
top of the oven. Per Warm-
ing Drawer
Requirement
Anti-Tip Block
Against Rear
Wall Per Warm-
ing Drawer
Requirement
2" {5.1 cm}
Min.
i" (2.5 cm) Min. Above Toekick or
Adjust to Oven Installation Height
NOTE: Additionol cleoronces between cutouts moy
be required. Check to be sure the oven supports
obove the Worming Drower locution do not ob-
struct the required interior depth ond height.
1" {2.5 cm) Min. Above Toekick
When instolling o Monogrom Worming Drower
below o single or double oven, o seporote 120V,
60 Hz, properly grounded receptocle must be
instolled. Refer to
instollotion instructions pocked with the
Worming Drower for specific instollotion
requirements.
Cutout for
Frameless Cabinets
Whenever possible, order 30" (76.2 cm)fromeless
cobinet with the cutout sided to fit
the oven. If using stock cobinets, odditionol fin-
ished filler pieces moy be required to
cover the opening.
, A stock frumeless cobinet cutout width
moy be up to 28 5/4" (73 cm). If necessory, odd
1/2" (1.3 cm) cleots to the sides, flush with the
front edge of the side ponels to occept mount-
ing screws.
Frameless Cabinets
_ 30':
{76.2 cm} ....
Install 1/2"
11.3cm)
Cleats to
Hold Oven
Mounting
Screws ........
-I
Double
51 15/16" (131.8 cm)
Single
27 5/16" (69.2cm)
l.
I
28II2" (72.4cm} -1]
Min,
285/8" (72.7cm}
Mox,
i
Cabinet Depth
23 1/2" (59.7 cm)
Min. From Inside
Back to Front of
Cabinet Frame
or Side Panel
3/4" (1.9 cm) Min.
Thick Bottom Shelf
Cut Back Flush with
Front of
Side Panel
7