GE ZET1 Installation Instructions Manual page 3

Installation Instructions
Temperature
Probe
Pre-lnstallation Checklist
Remove packaging materials.
Check behind hinges and under
false bottom. Remove labels on the outside
of the door, plastic on trims
and panel, all tape around the oven,
and any shipping screws securing
the oven to the base pad.
Reck Supports
with Hex Nuts
Graphite
Lubricant
Broiler Pen Literature
end Grid Peck
Open oven door and remove
literature pack, broiler pan and grid, oven
racks, rack supports and a bag with 9 hex
nuts.
Read Installation Instructions carefully
before you begin.
Be sure to place all literature, Owner's
Manual, Installations, etc., in a safe place
for future reference.
To Remove the Door (if
necessary)
Door removal is not a requirement for
installation of the product, but is an added
convenience. To remove the door:
Open the oven door as far as it will go.
Push both hinge
locks down toward
the door frame,
to the unlocked
position. This may
require a flat-blade
screwdriver.
_ Hinge Lock
(Unlocked
_'ii!/<_._/position)
Hin_i
Hinge Arm
Place hands on both sides
of the door, and close the
oven door to the removal
position, which is most of
the way closed.
Lift door up and out
until the hinge arms
clear the slots.
Removal Position
Hinge
Clears Slot
NOTE: The oven door is very heuvy. Be sure you
heve _ firm grip before lifting the oven door
off the hinges. Use caution once the door is
removed. Do not lay the door on its hendle. This
could cuuse dents or scratches.
Place the oven on a table or platform
even with the cutout opening. (Platform
must support 175 Ibs. [79 kg] single, 350
Ibs. [159 kg] double.)
Remove the bottom trim from the top of
the oven. It will be installed at the end
of the installation process. The trim is
wrapped separately and taped to the
top of the unit.
3