GE ZET1 Installation Instructions Manual page 9

Installation Instructions
Electrical Connections
ATTENTION INSTALLER
All electric wall ovens must be hard wired
{direct wired)into an approved junction box. A
plug and receptacle is NOT permitted on these
products.
DO NOT shorten the flexible conduit.
The conduit strain relief clamp must be
securely attached to the junction box
and the flexible conduit must be securely
attached to the clamp. If the flexible conduit
will not fit within the clamp, do not install
the oven until a clamp of the proper size is
obtained.
NOTE TO ELECTRICIAN: The 3 power leads
supplied with this appliance are
UL recognized for connection to heavier gauge
household wiring. The insulation
of these 3 leads is rated at temperatures much
higher than the temperature rating
of household wiring. The current carrying
capacity of the conductor is governed
by the wire gauge and the temperature rating
of the insulation around the wire.
WARNING:Improper 1
III _ connection of aluminum house Ill
Ill wiring to copper leads can result Ill
Ill in an electrical hazard or fire. Use only Ill
Ill connectors designed forjoining copper to III
Ill aluminum and follow the manufacturer's III
Turn off the circuit breGker or remove
fuses to the oven brGnch circuit.
With the oven supported on c] tGble
or plGtform in front of the cGbinet
opening, connect the flexible conduit
to the electricc]ljunction box Gs shown
below. Position the conduit in such
c] mGnner thc]t it will lie on top of the
oven in G natur(]l loop when the oven is
instGIled. You will need to purchGse
Gn GppropriGte strGin relief clGmp to
complete the connection of the conduit
to the junction box.
Junction Box
Location
Conduit
Strain Relief Clamp
Place oven on a Inot included}
support to assist in must be used at
connecting conduit Junction Box
9