GE ZET1 Installation Instructions Manual page 4

Installation Instructions
Allow 11/16"
(1.75 cm) for
overlapof
oven over
side edges
of cutout
Cutout for Single
Cutout Width
28 1/2" Min. 7 3/4"
(] n}
28 518" Max.
J_{72.4 to 72.7
Opening
Between
Inside
Walls Must
Be At Least
28 1/2"
(72.4 cm}
Wide
21"
(53.3
...... Allow1"(2.5 cm}
.......
minimum for
overlap of oven
Allow a minimum top and 1¼"
of 21" (53.3 cm} for I {3.2 cm} overlap
clearance to adjacent L of oven bottom of
corners, drawers, wails, L_ cutout
etc. when _ _'_ Cabinet
door is open " _ Width
30" {76.2 cmL
27 1/4" Min.
27 5/16" Max.
{69.2 to 69.4 cm
uilt-ln Oven
Junction
Box Location
{junction box
may be located in
adjacent
cabinet}
Recommended cutout
location from floor 32
112" {82.6 cm}
22" {55.9 cm}
Min. to Bottom
of Junction
Box
Cabinet Width
Recommended
Cutout Location
from Floor
Cutout Depth
Cutout Width
Cutout Height
30" (76.2 cm)
32 112"(82.6 cm)
23 1/2"(59.7 cm) Min.
28 1/2"{72.4 cm) Min.
28 5/8"(72.7 cm) Max.
27 1/4"(69.2 cm) Min.
27 5/16"(69.4 cm) Max.
NOTE: If the cabinet does
not have a front frame and the
sides are less than 3/4" (1.9 cm)
thick, shim both sides equally to
establish the cutout width.
If the cabinet does not have a solid bottom, two
braces or runners must be installed level with
the bottom of the cutout to support the weight
of the oven. For single ovens, the runners and
braces must support 200 Ibs. 190 kgl.
NOTE: If marks, blemishes or the cutout
opening are visible above the installed
oven, it may be necessary to add wood
shims under the runners and front trim
until the marks or opening are covered.
Side by Side Installations
InstGII two wall ovens in separate cutouts.
Allow 2" (5.1 cm) min. between cutouts.
Cutout -
Observe all
dimensions
and
requirements.
2" (5.1 cm)
Min.
Cutout -
Observe all
dimensions
and
requirements.
Suitable
Bracing
to Support
Runners
Install a
solid bottom
or 2" x 4"
{5 cm x 10 cm} or
equivalent runners
level with bottom
of cutout
21 5/8" I
{54.9 cm)
Over Centerline /
of Cabinet
The solid bottom or runners must be level with
the bottom of the cutout, or the bottom trim
may not install correctly and then interfere
with the door opening.
This oven is not approved for stackable
installation,
4