NETGEAR N300 Wireless Router JWNR2000v2 User Manual
Locate the cable (A) that is still attached to your computer. Insert that cable into a yellow
4.
LAN port on the router, as shown in the following figure:
Figure 6. Connect the Ethernet cable to a LAN port on the router
Connect any additional wired PCs to your router by inserting an Ethernet cable from a PC
5.
into one of the three remaining LAN ports.
Start your network in the correct sequence, as described below.
6.
CAUTION:
Failure to start or restart your network in the correct sequence could
prevent you from accessing the Internet.
To start your network:
Plug in and turn on the cable or DSL modem. Wait 2 minutes.
1.
A
Chapter 1. Hardware Setup
| 13