Grizzly G0632 Owner's Manual page 28

4.
Use the motor tensioning handle to lift the
motor assembly all the way up and re-tighten
the motor mount cap screw—this will hold the
motor in place while you change the belt posi-
tion.
5. Reach into the belt access cavity and roll
the belt onto the desired set of pulleys (see
Figure 31).
����������
����������
�����
Figure 31. Speed range belt positions.
Always choose the correct speed for your
particular turning project. As a general rule,
the larger the workpiece diameter, the slow-
er the speed. Always start the lathe on slow
speed. Failure to heed this warning could
lead to serious personal injury.
6.
Loosen the motor mount cap screw and lower
the motor.
-26-
�������
���������
����������
7.
Apply downward pressure on the motor ten-
sioning handle to properly tension the drive
belt and re-tighten the motor mount cap
screw.
Note: When properly tensioned, the belt
should deflect about
sure is applied to the belt mid-way between
the upper and lower pulley (see Figure 32).
����������
Figure 32. Testing for
8. Replace the front belt access panel.
G0632 16" x 42" Variable Speed Wood Lathe
⁄ " when moderate pres-
1
4
������
������
⁄ " belt deflection.
1
4