Table of Contents
Advertisement
Maintaining maximum cutting capacity
This tool
I S
factory adjusted to provided the max. cutting capacity for
a
305 mm (12") saw
blade. When using a saw blade other than the 305 mm (12") saw blade, adjust the lower
limit position of the blade
as
follows:
First unplug the tool. Push the carriage toward the guide fence fully and lower the handle
completely. Use the socket wrench to turn the adjusting bolt until the periphery of the
blade extends slightly below the top surface of the turn base at the point where the front
face of the guide fence meets the top surface of the turn base. With the tool unplugged,
rotate the blade by hand while holding the handle a l l the way down to be sure that the
Periphery
I
of
blade
n
blade does not contact any part of the lower base. Re-adjust slightly, if necessary.
To
surface
of
turn
base
of
turn
base
Guide fence
I
I
CAUTION :
After installing a new blade, always be sure that the blade does not contact any Part of
the lower base when the handle is lowered completely.
Positioning for adjusting the miter angle
The turn base turns up to 60" to the left
and right. Loosen the grip and turn the
turn base to the position where the pointer
points to the desired angle on the miter
scale. Then, tighten the grip firmly to secure
turn base.
-Miter
scale
I
CAUTION :
When turning the turn base, be sure
to
rasie the handle fully.
After changing the miter angle, always secure the turn base by tightening the grip firmly.
10
Hide quick links:
Advertisement
Table of Contents
