Maintaining Maximum Cutting Capacity; Positioning Kerf Board - Makita DLS713 Instruction Manual

With the blade guard so positioned, cleaning can be
more completely and efficiently accomplished. When
cleaning is complete reverse procedure above and
secure bolt. Do not remove spring holding blade guard. If
guard becomes damaged through age or UV light
exposure, contact a Makita service center for a new
guard. DO NOT DEFEAT OR REMOVE GUARD.

Positioning kerf board

1
2
011240
1 2
3
4
001800
This tool is provided with the kerf boards in the turn base
to minimize tearing on the exit side of a cut. The kerf
boards are factory adjusted so that the saw blade does
not contact the kerf boards. Before use, adjust the kerf
boards as follows:
First, remove the battery cartridge. Loosen all the screws
(2 each on left and right) securing the kerf boards.
Re-tighten them only to the extent that the kerf boards
can still be easily moved by hand. Lower the handle fully
and push in the stopper pin to lock the handle in the
lowered position. Loosen two clamp screws which
secure the slide poles. Pull the carriage toward you fully.
Adjust the kerf boards so that the kerf boards just contact
the sides of the blade teeth. Tighten the front screws (do
not tighten firmly). Push the carriage toward the guide
fence fully and adjust the kerf boards so that the kerf
boards just contact the sides of blade teeth. Tighten the
rear screws (do not tighten firmly).
After adjusting the kerf boards, release the stopper pin and
raise the handle. Then tighten all the screws securely.
NOTICE:
After setting the bevel angle ensure that the
•
kerf boards are adjusted properly. Correct
adjustment of the kerf boards will help provide
proper support of the workpiece minimizing
workpiece tear out.
1. Thumb screw
2. Kerf board
1. Saw blade
2. Blade teeth
3. Kerf board
4. Left bevel cut
5. Straight cut
5

Maintaining maximum cutting capacity

1
2
3
011265
2
3
005516
This tool is factory adjusted to provide the maximum
cutting capacity for a 190 mm saw blade.
Remove the battery cartridge before any adjustment is
attempted. When installing a new blade, always check
the lower limit position of the blade and if necessary,
adjust it as follows:
First, remove the battery cartridge. Push the carriage
toward the guide fence fully and lower the handle
completely. Use the hex wrench to turn the adjusting bolt
until the periphery of the blade extends slightly below the
top surface of the turn base at the point where the front
face of the guide fence meets the top surface of the turn
base.
With the battery cartridge removed, rotate the blade by
hand while holding the handle all the way down to be
sure that the blade does not contact any part of the lower
base. Re-adjust slightly, if necessary.
WARNING:
After installing a new blade and with the battery
•
cartridge removed, always be sure that the
blade does not contact any part of the lower
base when the handle is lowered completely. If
a blade makes contact with the base it may cause
kickback and result in serious personal injury.
8
1. Adjusting bolt
2. Guide fence
3. Turn base
1. Top surface of
turn table
1
2. Periphery of
blade
3. Guide fence