SP6733-1 Ridgid WD1851 ES
Drum/Caddy Assembly (continued)
Installing Tool Holder
Install tool holder as shown with
extension wand holders facing unit.
Wet/Dry Vac Assembly
1. Position the powerhead assembly on
the drum/caddy assembly as shown
(assembled earlier).
2. Rotate both latches down and press
until you hear them snap over the
flanges on the drum.
Insert Hose
Insert the push button end of the "Tug-A-
Long" hose into the inlet of the Vac. The
hose should snap into place. To remove
the hose from the Vac, press the release
button in the hose assembly and pull the
hose out of the Vac inlet, as shown.
Press
Release
and
Button
Pull
10/4/10
9:08 AM
Drum
Latch
10
Page 10
Tote Snaps
Powerhead
Assembly
Latch
Drum
Tote
Straps (4)
Handle
Drum
Latch
Drum
Flange